Engineering Drawing Multiple Choice Questions and Answers for Practice

16. In isometric drawings:

1. Two axes are perpendicular
2. True measurements can be made only along or parallel to the isometric axes
3. All faces are unequally distorted
4. None of the above

17. In offset sections, offsets or bends in the cutting plane are all

1. 90 degrees
2. 180 degrees
3. Either 90 or 180 degrees
4. 30, 60, or 90 degrees

18. Non-isometric lines are located and sketched how?

1. They are drawn parallel to the isometric axis.
2. They are measured using the angle from the multiview.
3. They are measured using a non-isometric template.
4. They are located by determining the endpoints of the non-isometric line.

19. Objects that are symmetric can be shown effectively using this type of section

1. Quarter section
2. Half section
3. Full section
4. Symmetric section

20. One method of drawing an ellipse that represents an isometric pictorial circle is known as:

1. the box construction method
2. the coordinate construction method
3. the four-center approximation method
4. the offset construction method

21. The dotted lines represents

1. Hidden edges
2. Projection line
3. Centre line
4. Hatching line

22. The following is not included in title block of drawing sheet

1. Sheet No
2. Scale
3. Method of Projection
4. Size of sheet

23. The following line is used for dimension line

1. Continuous thick
2. Continuous thin
3. Chain thin line
4. Short zigzag thin

24. The following line is used for visible outlines

1. Continuous thick
2. Continuous thin
3. Chain thin line
4. Short zigzag thin

25. The internal angle of regular hexagon is ___ degree

1. 72
2. 108
3. 120
4. 150

26. The internal angle of regular pentagon is ___ degree

1. 72
2. 108
3. 120
4. 150

27. The section view drawing in which one fourth of an object has been marked for removal is known as a ________ section

1. Full
2. Half
3. Quarter
4. none of the above

28. This type of section is not in direct projection from the view containing the cutting plane

1. Revolved section
2. Removed section
3. Broken-out section
4. Full section

29. To avoid having to dimension to a hidden feature the drafter can utilize a ________ section

1. Whole
2. Half
3. broken out
4. all of the above

30. What type of sketch incorporates convergence?

1. isometric
2. perspective
3. oblique
4. multiview